Given the odd geometry, I'd definitely end up with a bunch of framing and drywall work if I tried to stick in a new tub. Refinishing over replacing also reduces downtime of the bathroom. If I replaced it, I would have to step down to some odd small width and lose bathing space, or get a normal 30" tub which would put it annoyingly close to the toilet. I can't justify the cost of a new cast iron tub, yet it seems like a shame to stick a plastic tub in a house that retains much of its historic charm.Īlso, the unique geometry of the existing tub preserves walking space in a narrow bathroom (1872 house, definitely shoehorned in after), while also being compatible with standard shower doors (not a "curved" tub). It's an old 2-family house in a neighborhood mostly full of grad students and young professionals. There are quite a few reasons that I'd like to keep the existing tub. I do understand that it isn't the perfect solution. Lots of good feedback from other customers. I got a quote from someone who's been doing refinishing for many decades, which I think is my best option. Westbrass 3-1/8' Two-Hole Overflow Face Plate and Screws, Stainless Steel, D329-20. FREE delivery Wed, Oct 4 on 35 of items shipped by Amazon. The flange diameter looks to be 2 3/4:īecause this is the only bathroom in that unit, I don't want to take the drain apart, possibly breaking something, then end up having to wait weeks for my supply house to get the repair parts (if they exist). Trip Lever Bath Drain Trim Kit - Overflow Drain Cover for Bathroom Tub BN. What I'm hoping to install is a typical Gerber drain. Kohler's site says its all discontinued but I believe service parts are available: Which led me to this diagram, which I think is what I have now. Good discussion about this drain/tub type here: If the upgrade is not possible, I'll have to piece together the repair parts for a cosmetic repair, and also address why water pours into the basement when the water level reaches the overflow (bad gasket I'm assuming). But I don't know if there's enough "meat" on the tub to seat the smaller OD drain. What I'm hoping to do is take it all out and replace it with a newer drain assembly, this will be easy since the walls will be open. It's larger than standard size, see below. I would prefer to leave it in place due to the hassle of removal, and it just seems right in an older building. It's a kohler cast iron tub in refinishable condition. Hole on top will release excess water from tub into overflow drain.I'm about to do a tile job in my bathroom, and trying to finalize the decision about the tub - keep or replace.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |